Abrasive spiral bands, cylindrical
Abrasive spiral bands, cylindrical
Spiral BandFor coarse grinding work with a high stock removal rate and cool grinding. Active grinding additives in the coating substantially improve the stock removal rate, prevent loading and result in cooler grinding. In ISO 2421, abrasive spiral bands are designated as "cylindrical sleeves". GSB = bulk pack of abrasive spiral bandsSpecial featuresAbrasive spiral bands fit securely on the rubber drum holder as the holder expands during use.Outstanding service life even under the toughest work conditions, due to special manufacturing.Highest possible cost-effectiveness due to particularly high stock removal rate and aggressiveness of the abrasive.ApplicationsDeburringStep-by-step fine grindingLevelingRougheningSharpeningSurface workWork on weld seamsWorking on edgesMaterials that can be workedStainless steel (INOX)Steel materials with a hardness > 54 HRCSteels up to 370 HV (< 38 HRC)TitaniumTitanium alloysAnnealed cast ironBronzeCast steelCobalt-based alloysGrey/nodular cast iron (GG/GJL, GGG/GJS)Hardened, heat-treated steels over 370 HV (38 HRC)Nickel-based alloys (e.g. Inconell and Hastelloy)Recommendations for useTo easily change the abrasive spiral bands, give them a slight clockwise twist and pull them up and off. When doing so, leave the rubber drum holder clamped in the power tool.To ensure the abrasive spiral band is securely attached, follow the minimum speed for the rubber drum holder.For the best performance, use with a recommended peripheral speed of 4,000-6,000 SFPM.Use the appropriate grinding oil for the material to significantly increase the service life and the abrasive performance of the discs.SafetyThe maximum permitted peripheral speed is 6,000 SFPM.For safety reasons, the maximum permitted rotational speed indicated must never be exceeded.Do not allow abrasive spiral bands to protrude beyond the rubber drum holder.Technical informationDia. External1 1/8 inDrive typeFlexible shaft driveGrit36Pack qty100